Microcom 322M Manual del operador descargar pdf (Pagina 68)

Downloadable Graphics Chapter 7

64 322M Operator’s Manual

7.4 Downloadable Graphics Command Summary

The following commands refer to the use of downloadable fonts and graphics:

^D COMMAND

100 Clear User RAM: This command clears all downloadable fonts, graphics, and

stored label formats.

101 List Memory Bytes Available: The printer will send the “>” character followed

by the amount of available bytes and then finally a “<” character. (i.e.

>192690<)

XX 104 Load Graphic Images or Fonts into User Memory without Compression:

The ^Axx specifies which memory slot to place the image/font (1-255). This

command should be used with an ASCII-HEX file that contains only printable

characters less then 80 HEX. This command supports graphics over 64KB.

XX 106 Load Graphic Images or Fonts into User Memory without Compression:

This command is intended for legacy support only and Microcom Corporation

recommends either the ^D104 or ^D107 commands. Fonts must be less than

64KB for this command to function.

XX 107 Load Graphic Images or Fonts into User Memory using Binary

Compression: The ^Axx specifies which memory slot to place the image/font

(1-255). This command will greatly reduce the image download time and

should be used whenever possible. This command may only be used with 8-

bit data connections and will not function on 7-bit data connections.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 119 120

Sin comentarios

Microcom 322M Manual del operador Pagina 68