Microcom 466 Manual del operador descargar pdf (Pagina 46)

Printer Commands Chapter 5

466 Operators Manual40

^A ^D COMMAND

25 Change SW5: Change software switch bank #5.

12345678

^ABxxxxxxxx

*******.) 1=XON/XOFF Enable, 0=Disable (COM2)

******.)) 1=8 Data Bits, 0=7 Data Bits (COM2)

*****.))) 1=Echo Enable, 0=Disable (COM2)

****.)))) 1=No Parity, 0=Enable Parity (COM2)

***.))))) 1=Odd Parity, 0=Even Parity (COM2)

**.)))))) 1=Ignore Control Codes, 0=Accept (COM2)

*.)))))))))),

.)))))))))),* Status Message Format (COM2)

00 = Control Codes

10 = Text Equivalent

11 = ^ Equivalent

Position:

1,2 Status Message Format (COM2): This determines what the printer will send

back in response to an enquiry. See Section 5.2.

3 Control Codes (COM2): This switch setting will allow or disallow printer

response to control codes (below 20h).

4 Parity (COM2): Selects either even or odd parity error checking.

5 Enable Parity (COM2): Enables or disables parity error checking.

6 Echo (COM2): If this feature is enabled, the printer will echo all received

characters to the serial port.

7 Data Bits (COM2): Choose 7 or 8 bit data.

8 XON/XOFF (COM2): Enable or disable XON/XOFF software handshaking.

CTS/RTS hardware handshaking is always enabled.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 98 99

Sin comentarios

Microcom 466 Manual del operador Pagina 46