Microcom 466 Manual del operador descargar pdf (Pagina 94)

Quick Reference Command Summary Appendix B

466 Operators Manual88

XX 88 Load Field Number to Increment by 1: For multiple serial numbers.

XX 89 Load Field Number to Decrement by 1: For multiple serial numbers.

XX 90 Piezo Beep Control: Enter number of times to beep pieze before turning it off.

This setting is used to control the number of times that the pieze beeps after an

error occurs. A value of 0 will produce a continuous beep.

XX 91 Load Value for Printer to See Valid Gap. Section 5.3.

XX 92 Load Value for Slices to Process: This command adjusts the number of slices

generated before the drive motor starts moving. The default is 256 and the

valid range is 1 to 366.

93 Load Control Code Recognition Status:

0 Enable control code recognition.

1 Disable control code recognition.

94 Piezo On/Off:

0 Enable piezo.

1 Disable piezo.

XX 95 Load User Defined Steps for Label to Advance:

XX 96 Load Advance Delay: ^A specifies how many milliseconds to delay

repositioning of the label in tag/tear and peel-and-dispense modes.

97 Tag/Tear Operation:

0 Turns off tag/tear operation.

1 Advance after every label.

2 Advance after copies count.

3 Advance when idle.

98 Peel-and-Dispense Mode: Sections 2.5.2 and 5.3.7

0 Turn off peel-and-dispense mode.

1 Turn on peel-and dispense mode.

2 (Custom Applicator Mode - peel and dispense with no delay.)

99 Cutter Control:

0 Disable cutter.

1 Enable cutter.

100 Clear User RAM: This command will clear all downloaded fonts, graphics, and

stored label formats. See Section 5.3.8.

101 Send User RAM Available: The printer will send the number of free bytes to the

serial port (ie. >699842<).

1 2 ... 89 90 91 92 93 94 95 96 97 98 99

Sin comentarios

Microcom 466 Manual del operador Pagina 94