Microcom 470 Manual de instrucciones descargar pdf (Pagina 27)

©INCOE® CORPORATION 8/2010

Pg. 26

www.incoe.com

M SERIES

INSTRUCTION MANUAL

OPERATION



Turn to on the line ”Activate MoldScan option” with

the left and right arrows, then validate; this is done

from the System page (CFG1) or in the MODIF menu.

: when this feature is

selected, a diagnostic on the zone(s) in automatic

mode and currently under temperature low or high

alarms is performed. A new Scan is carried out on

these zones until the alarm disappears. When not

selected, the Analysis can be started manually with

the Scan menu.

A fourth main page is displayed when the line

“Active MoldScan function “ is ON:

A: shows the type of control zone (16A cards or

5A cards). Depends on the conﬁguration of the

cabinet.

B: to manually start the Scan of the tool.

C: to display all parameters for the mold Analysis.

  

- Amps for each control zone.

- Power (in Watts) for each control zone.

- Resistance (in ohms) of each heating element.

- Response time (in °/min) for each control zone

D: to show all alarms recorded in logbook.

E: to display actual temperature for each control

zone and their setpoint in a graphical form.

B C D E F

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 45 46

Sin comentarios

Microcom 470 Manual de instrucciones Pagina 27