Microcom 428TM Manual del operador descargar pdf (Pagina 101)

Chapter 5 Printer Commands

428TM Operator’s Manual - 880042-0141 5-31

Setting of 24 = 255.0.0.0

Setting of 16 = 255.255.0.0

Setting of 8 = 255.255.255.0

Change Telnet Configuration Password

Setting the Telnet configuration password prevents unauthorized access to the

setup menu via a Telnet connection to port 9999 or via web pages. The

password must have 4 characters.

After setting up the configuration, a selection of 9 will Save and Exit.

Once exiting this mode, a hardware reset is required to restore normal printer

operation.

5.2.3 Print Head Size Commands

The different printer models may be configured with a variety of different print head sizes

and densities. The ^D78 and ^D79 commands (non-volatile) allow the printer to be setup

through software to configure the different print head sizes and densities. Power cycle or

^D32 is required before command settings take affect.

Note: When using these commands, the ^D79 command MUST be sent prior to the ^D78

^A ^D COMMAND

X 79 Set print head dots/inch (dpi). This command sets the dot density of the

print head.

0 203DPI: This sets the printhead resolution to 203dpi. This requires that a

203dpi printhead is installed on the printer. If the setting is not set properly,

the printed image could produce

1 300DPI: This command the printhead resolution to 300dpi. This requires that

a 300dpi printhead is installed on the printer. If the setting is not set properly,

the printed image could produce

The only valid entries are ^A0 for 203dpi and ^A1 for 300dpi.

XX 78 Set print head number of dots. This command sets # of dots in the print

head. This command MUST be sent AFTER the dot density (dpi) is set with

the ^D79 command. The only valid entries for XX are the numbers in the “# of

Dots” column in the table above.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 242 243

Sin comentarios

Microcom 428TM Manual del operador Pagina 101